Turn your Galactus LED Popcorn Bucket into a clean, display-ready centerpiece — without constantly swapping button batteries.
This Fusion Reactors kit converts the bucket’s original 3× LR44 battery power into stable USB-powered lighting, so your eyes/LEDs stay bright for shelf display, photos, or movie nights.
Why You’ll Want This
No More Button BatteriesReplaces the original 3×LR44 (AG13) setup with a USB power solution.
Stable, Consistent BrightnessUSB power keeps the LED output more consistent compared with draining button cells.
Collector-Friendly & Clean InstallDesigned to sit inside the existing battery compartment, with a thin wire run for a neat finish.
Power & Compatibility
Made for: Galactus LED Popcorn Bucket (uses 3× LR44)
Power input: 5V USB-A (use a normal USB wall adapter or power bank)
What’s Included
1× Fusion Reactors USB conversion module (pre-wired)
1× Battery replacement adapter to match 3×LR44 compartment fitment
Installation (Simple)
Open the bucket’s battery compartment and remove the LR44 batteries.
Insert the Fusion Reactors adapter in the same orientation as the batteries.
Route the wire neatly and close the compartment.
Plug into any 5V USB source to power the LEDs.
⚠️ IMPORTANT DISCLAIMERS
Display Photos OnlyAny photos showing the bucket lit up are for demonstration purposes only.✅ This listing is for the light/power kit only.❌ Popcorn bucket / props not included.
Use With Correct Power Only
Use 5V USB only.
Avoid “fast charge”/high-voltage outputs if your adapter can switch modes.
If unsure, use a standard 5V phone charger or a power bank.
Compatibility NoteThis kit is intended for 3×LR44 Galactus bucket setups. Using it on other products may cause incorrect operation or damage.
Galactus Popcorn Bucket – USB LED Power Conversion Light Kit
How to use:
- Insert the dummy into the battery compartment, connecting the red (+) and black (-) terminals.
- Place the dummy on the spring side at a 45-degree angle. Use flathead tools to gently push it down, then use your finger to push it all the way inside.
- Ensure that the light switch is turned on and that both metal contacts are touching.
- Do not swap USB cables among other kits unless they have a male USB port.
- Plug the USB cable into the power adaptor.
- Close the compartment with the cable lead next to the screw to create more space.
Warning and Safety Manual:
- Do not pull on the cable or remove, open, or unplug it frequently, as this may cause damage.
- Keep the device in a shaded or room-temperature environment.
- Avoid using exposed cables.
- Do not let the black and red wires touch each other.
- Do not use a fast-charging USB adaptor.
Safety Tips:
- This device is not intended for children under the age of 15 and should not be left unattended for extended periods.
- Only turn on the device when supervised, and it should be used for a maximum of 3 hours at a time.
- Stop using the device immediately if you notice any changes in the light colour, flashing LED, or if it does not turn on.
Troubleshooting:
- Ensure that all dummy cells are inserted and the switch is turned on before plugging in the power adaptor.
- If the compartment is closed too tightly, it may cause the dummy cells to pull out, so adjust the compartment as needed to ensure that the copper contacts are touching each other.
- Close the compartment with a gentle push, but do not apply excessive force, as this may damage the device.
Recommended:
- Power adaptor (5V, 2A output - not included)
- USB 2.0 cable
Note: The Mark 46 and Mark 47 models do not include a shoulder back light kit.
#Fusion_reactors
